BAUKNECHT WA 7363/WS-D
Guía de consulta rápida

GB Overview of consumption data
Programme Duration* �Rinse Hold� button (hour : minutes) Temperature Max. Load Water Energy (°C) (kg) (l) (kWh)

Programme approx. � The laundry remains in last rinse water without progressing the final spin cycle to avoid

Cotton 95 5.0 44** 1.60 1 : 55

creasing and prevent colours from changing. � This option is particularly recommended for the programme �Synthetics� or �Delicates�.

Coloured Cotton 60 5.0 39 0.95 2 : 00 � This function is particularly useful if you want postpone spinning to a later time.

Coloured Cotton 40 5.0 39 0.55 1 : 45 Note: The programme stops to at time the �Rinse Hold� button light flashes.

Coloured Cotton + Rapid 30 3.0 32 0.40 0 : 50 Terminate the �Rinse Hold� option:

Synthetics 60 2.5 55 0.70 1 : 30 � Press �Rinse Hold� button again; programme will terminate automatically with the final

Synthetics 40 2.5 50 0.50 1 : 15 spin cycle for the present wash programme.

Programme 3.0 35 0.40 0 : 30 � If you do not wish spin clothes, turn selector knob to the drain programme

Wool 1.0 50 0.50 0 : 40

Handwash cold 1.0 0.20 0 : 35

and press the �Start/Pause� button again. Delicates 30 1.5 50 0.50 0 : 45 �Spin Speed Reduction� button � Every programme has an automatic predefined maximum spin speed. � Press the button to set another spin speed.

Prewash cycle increases programme duration by approximately 15 min. Consumption values were measured in � If spin speed �0� selected, the final spinning cancelled. The water is drained out only. normalized conditions in compliance with Standard IEC 60 456. The data on the �Energy Label� refer to programme

PROGRAMME START �Coloured Cotton 60 °C�. Consumption data home may vary with respect values the table in relation to

water supply pressure temperature, load type wash. Open tap and press button. The pilot lamp of the �Start/Pause� button lights * remaining time can similarly deviate from values table, because it takes into account up. The indicator lamps show sequence reached in programme. After starting the programme,

** To reduce temperature, some cold water is added at end of the main wash cycle, before programme is finished the corresponding lamp goes out.

the household conditions applicable at that time. indication runs from left to right through Wash, Rinse, Spin. When sequence of the

pump drains the water out.

DOOR LOCK ADD DETERGENT, CLOSE DOOR AND SELECT THE PROGRAMME
During first 15 minutes of cotton and synthetics programmes the door can be opened for adding further laundry. This not possible if �Rapid Wash� is selected. programme selector knob The door can be opened when the �Door Free� indication is shining.

Add detergent as described chapter �Detergent and Additives� in the booklet. 1. Turn to the desired programme and temperature. � The remaining time display shows duration of the chosen programme (in hours and minutes)

PROGRAMME END and pilot lamp of the �Start/Pause� button is flashing.
1. Turn programme selector to the � � position. PRESS ANY DESIRED OPTION BUTTON(S). The pilot lamp lights up. 3. Open door and unload the machine. is not possible. Unsuitable combinations of options are deselected automatically.

2. predefined spin speed corresponding to � The remaining time is on �0:00� and all lights of the programme sequence indication are off.

selected programme lights up. A short audible tone sounds three times.

An audible tone sounds if the combination of programme, additional options and temperature 2. Turn the water supply tap off.

�Eco Wash� button CHANGE THE AND OPTIONS AFTER PROGRAMME START � duration wash is extended and temperature reduced save up 40% of energy 1. Press �Start/Pause� button to pause the programme. The light flashes. maintaining good washing results. 2. Select the new programme, any options and another spin speed if you want it. �Rapid Wash� 3. Press �Start/Pause� button again. The new programme continues at the same position where � For quick, economical washes. Ideal minimum loads of lightly-soiled articles. the previous programme was interrupted. Do not add detergent for this programme. �Prewash� button TO CANCEL A PROGRAMME BEFORE THE END � Only for heavily soiled loads (for example sand, granular dirt) sensible. The cycle time increases by approximately 15 min. �Intensive Rinse� button shows 2 minutes. � A further rinse cycle is added. 3. Press �Start/Pause� button to start the drain programme. � This option is particularly suitable for areas with very soft water washing baby linen and helps people with allergies. 1. Press �Start/Pause� button to pause the programme. The light flashes. 2. Set programme selector to �Drain�. The spin indicators show �0� and the remaining time